HP Xw6600 - Workstation - 2 GB RAM Technical Reference Manual

Also see for Xw6600 - Workstation - 2 GB RAM: Installation guidelines Brochure & specs Safety and regulatory information User manual Compatibility chart

Contents

Power supplyThis section describes how to remove the power supply.Removing the power supplyTo remove the power supply:1. Disconnect power from the system (see Predisassembly procedures on page 52).2. Remove the side access panel (see Side access panel on page 58).3. To ease installation of the power supply, write down the numbers on the cables so you can easilyreconnect them to the correct devices.4. Remove the memory fan and chassis fan assemblies.5. Disconnect cables from the system board, drives, and cards.6. Remove the four screws from the back panel (1), as shown:Figure 4-23 Removing the power supply7. Slide the power supply toward the front of the chassis and lift it out of the chassis (2).Reinstalling or replacing the power supplyTo install the power supply, reverse the steps completed for removal.CAUTION: To prevent possible equipment damage, see Power connections on page 73 to ensureproper connection of power supply cables.72 Chapter 4 Removal and replacement procedures ENWW