HP Xw4600 - Workstation - 2 GB RAM Installation Manual

Also see for Xw4600 - Workstation - 2 GB RAM: Installation guidelines Brochure & specs Specification Safety and regulatory information User manual

Contents

Figure 10 Attaching the HDD-LED cableStep 4—Reassembling the workstation1. Reinstall the card support, if applicable.2. Reinstall the side access panel.3. Reconnect power to the workstation and all external devices.4. Restore power to the workstation and all external devices.Step 5—Loading and setting up driver softwareFor instructions on loading and setting up the SAS drivers for use with your workstation, see themanufacturer’s documentation shipped with the 8-port SAS RAID controller.At the time of component installation, look for device firmware and driver updates, designated for yourworkstation model and operating system. You can obtain updates from http://www.hp.com/go/workstationsupport.Step 6—Configuring RAID devicesNOTE: Verify the RAID card internal data connectors are enabled. For card setup instructions, seethe manufacturer's documentation included in this kit.For detailed instruction on configuring RAID devices, see the service guide for the HP workstation modelat http://www.hp.com/support/workstation_manuals.Additional information is available at http://www.hp.com/support/RAID_FAQs12 LSI MegaRAID® SAS 8888ELP Host Bus Adapter installation ENWW

/ 13

Related manuals for HP Xw4600 - Workstation - 2 GB RAM