HP T2200 XR User Manual

Contents

Operation2-2 HP Uninterruptible Power System T2200 XR Models User GuidecontinuedItem Description Meaning/Function6 Site Wiring FaultIndicator ( )Red—No ground connection exists between utility power and the UPS,the line and neutral connections between utility power and the UPSare reversed, or the UPS voltage configuration is incorrect.7 Utility LED ( ) Flashing Red—Utility input voltage is outside the +20% to -30%configured nominal range.Green—Utility voltage is present and output is on, or utility voltage hasreturned to the voltage range for which the UPS has been configured(UPS is supplying utility power and the audible alarm should be reset).Flashing Green—Utility voltage is present and the UPS is in Standbymode. Output is off. Batteries charge if needed.8 Bad Battery/LowBattery ( )Red—Battery is bad or low.9 On Battery ( ) Red—UPS is running on battery power.10 General Alarm ( ) Red—UPS detects a general alarm. Perform a self-test.11 Configure Mode OnLEDGreen—UPS is in Configure mode (seen when front bezel removed).12 Configure button Places the UPS in Configure mode (seen when front bezel removed).13 Test/Alarm ResetbuttonResets alarms or initiates self-tests.14 Standby button Places the UPS in Standby mode (turns output load segments off).15 On button Starts UPS powering the load.Modes of OperationThe UPS has three modes of operation:• Standby Mode— No power is available at the UPS output receptacles.— The UPS charges the batteries as necessary.• Operate Mode— Power is available at the UPS output receptacles.— The UPS charges the batteries as necessary.• Configure Mode— Power is available at the UPS output receptacles.— The UPS charges the batteries as necessary.— The UPS configuration can be updated.Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com