© 2004 Hewlett-Packard Development Company, L.P.Printed inwww.hp.comHP PE4240n 42" Plasma TelevisionStart HereThank you for purchasing anHP PE4240n 42" Plasma Television.■ Identify the type of connectors your home entertainmentequipment uses, then go to the corresponding step on thisposter and follow the directions. Example: To connect acable or satellite set-top box which connects via S-videocabling, refer to step 5, “Connect an S-video device.”■ Refer to the user documentation for advanced connections.■ Apply Power to all components and then to the TV.■ Finally, refer to the section titled “Setting up TV channels(Auto Scan)” in your user documentation to finalize yourTV setup.Contents■ HP plasma TV■ TV stand■ Speakerbars (2)(optional)■ Documentation kit■ Remote controlwith AA batteries (2)■ Speaker cables (2)(optional)■ Antenna cable■ AC power cableThe information in this document is subject to change without notice.1 TV Connector Panels 2a Attach Brackets toSpeakers (optional)2b Attach Speakers to TV3 Connect a PC or OtherDevice by DVI5 Connect an S-video Device 6 Connect a Composite Device4 Connect a Component(YPbPr) Device2c Connect Speaker Cables to TV8 Outdoor AntennaConnection9 Remote Control 10 Power On7 Analog Video from PCLeft speakerRight speakerDVITV OUT2 1VideoRight VideoInputsLeftAudioOutputsS-VideoL RRightLeftS-VideoInputsComponentVideoInputsRightLeftYPBPRTV ANTENNACABLE IN2 1YPB PR1: 480P/720P/1080iYPB PR2: 480iWallCoaxialCableSignalTV ANTENNACABLE INS-VideoRightLeftS-VideoInputsS-video Outputs2 1VideoRight VideoInputsLeftCompositeVideo OutputsStep 1Step 2Step 3YPBPR1: 480P/720P/1080iYPBPR2: 480iComponentVideoInputsRightLeftYPBPR2 1PbYPrRLComponentVideo OutputsOnce the power cable is connected, power on TV bypressing PWR on the remote control.Refer to the section in the user documentation titled“Setting up TV channels (Auto Scan)” to complete TV setup.Refer to the user documentation for advanced connections.