HP PL4245N Quick Setup Manual

Also see for PL4245N: User guide Support guide

7 Connect an S-videoDevice8 Connect a CompositeDevice6 Connect a Component(YPbPr) Device2 Attach Speakers to TV 3 Connect Speaker Cablesto TV4 Connect Subwoofer(optional)1 Attach Brackets toSpeakers11 Remote Control 12 Power On9 Analog Video from PCHP PL4245N 42" Plasma HDTVStart HereThank you for purchasingan HP PL4245N42" Plasma HDTVYour setup time may vary.■ Identify the type of connectors your homeentertainment equipment uses, then go to thecorresponding step on this poster and followthose directions. (Example: To connect a cableor satellite set-top box which connects viaS-video cabling, refer to step 7, “Connect anS-video device.”)■ Refer to the user documentation for advancedconnections.■ Apply power to all components and then tothe TV.■ Finally, refer to the section titled “Setting UpYour Channels” in your user documentation tofinalize your TV setup.Contents■ HP plasma TV■ TV stand■ Speakerbars (2)■ Documentation kit■ Remote controlwith AA batteries (2)■ Speaker cables (2)■ Antenna cable■ AC power cableThe information in this document is subject to change without notice.5 Connect a PC or anHP HD Tuner by DVI10 Outdoor AntennaConnectionAV AUDIO Y Pb PrL RDVIOnce the power cable is connected, power on TV bypressing PWR on the remote control.Refer to the section in the user documentation titled“Setting Up Your Channels” to complete TV setup.Refer to the user documentation for advanced connections.Connectors are located on the back of the TV, under the back panel.R PbY PrLComponent Video Outputs Composite Video OutputsWallCoaxialCableSignalAV AUDIO Y Cb/Pb Cr/Pr AUDIOAV Y Cb/Pb Cr/PrL RL ROUTS-video OutputsAVStep 1Step 2Step 3TV OUTDVI VGADVI© 2004 Hewlett-Packard Development Company, L.P.Printed inwww.hp.com

/ 1

Related manuals for HP PL4245N