84 HP Digital Entertainment CenterOne Cable TV Box or Digital Cable Receiver(NTSC) and Antenna (ATSC)To connect a standard set-top box (sold separately) andan HDTV/SDTV Ant. In input to your HP DigitalEntertainment Center using a standard set-top box,satellite receiver, or digital cable receiver with S-video orcomposite video output, do the following:1 Make sure that a coaxial cable connector from yourcable TV source (wall) is plugged into the set-top boxor digital cable receiver In connector.2 Connect a video cable:a Choose a video out connector:■ Coaxial (RF)■ Video (composite)■ S-videob Connect the video cable from the set-topbox or digital cable receiver back panel VideoOutput connector.c Connect the video cable into the HP DigitalEntertainment Center back panel TV Source 1 Inconnector.3 Connect stereo audio cables (skip this step if usingcoaxial [RF]):a From the set-top box or digital cable receiverback panel Audio Out right (red) and Audio Outleft (white) connectors.b Into the HP Digital Entertainment Center backpanel TV Source 1 In Audio right (red) and Audioleft (white) connectors.4 Connect the coaxial cable from the UHF/VHFantenna into the HDTV/SDTV Ant. In HDTV/SDTVAnt. In connector on the back of the HP DigitalEntertainment Center.5 Connect the set-top box Infrared Transmitter cable(required for signal). See “Infrared TransmitterConnection” on page 97.
