Step Q7 Configure the ProCurve Switchz Select an IP address from the same IP subnet that will be used for theCompute Nodes.z Connect a console to the switchz Log onto the switch through the consolez Type 'set-up'z Select IP Config and select the "manual" optionz Select the IP address field and enter the IP address to be used for theswitchFor more information, see the Comprehensive Instructions for this step.References:z Step 7 Configure the ProCurve SwitchBack to TopStep Q8 Copy the License Files to the Management ServerPut the files in any convenient directory on the Management Server (e.g. /tmp).For more information, see the Comprehensive Instructions for this step.References:z Step 8 Copy the License Files to the Management ServerBack to TopStep Q9 Install ClusterPack on the Management Serverz Mount and register the ClusterPack DVD as a software depot.z Install the ClusterPack Manager software (CPACK-MGR) usingswinstall.z Leave the DVD in the DVD drive for the next step.For more information, see the Comprehensive Instructions for this step.
