84Replacing hardware optionsIf you are replacing multiple hardware options, read their replacement procedures and identifysimilar steps to streamline the entire replacement procedure.Replacing the security bezel1. Insert the key provided with the bezel into the lock on the bezel and unlock the security bezel,as shown by callout 1 in Figure 115.CAUTION:To avoid damage to the lock, hold down the key while you are turning the key.2. Press the latch at the left end of the bezel, open the security bezel, and then release the latch,as shown by callouts 2 and 3 in Figure 115.3. Pull the right edge of the security bezel out of the groove in the right chassis ear to remove thesecurity bezel, as shown by callout 4 in Figure 115.Figure 115 Removing the security bezel4. Install a new security bezel. For more information, see "Installing the security bezel."Replacing a SAS/SATA driveThe drives are hot swappable.Procedure1. Remove the security bezel, if any. For more information, see "Replacing the security bezel."2. Observe the drive LEDs to verify that the drive is not selected by the storage controller and isnot performing a RAID migration or rebuilding. For more information about drive LEDs, see"Drive LEDs."3. Remove the drive:
