Menu
Ge Est QS4 Technical Reference Manual
                                                                                                                                          | |
Contents
| 
Programming instructionsQS4 Technical Reference Manual 4.21Setting up an Output GroupBefore you begin Before you begin, you should complete an Output GroupProgramming Worksheet (Figure 4-8) for each Output group.Keep a copy for your records.To set up an Output Group:1. On the control panel, press Menu.2. Choose Login then enter the password required for Level 4access.3. Choose Program > Configure > Output.4. To program a new Output group, choose Add.— or —To edit an existing Output group, choose Edit, select thegroup from the pick list, and then press Enter.5. Add the responses.6. After you finish entering the responses, you should reviewthem to make sure they are correct.Adding a response that activates anoutput circuit1. Choose Responses.2. Choose Active or Trouble3. Choose Add > Relay, then enter the circuit address whereCC is the card number and DDD is the circuit number.4. Choose the activation setting.5. Choose Exit > Save Edits.Adding a response that activates adelay1. Choose Responses.2. Choose Active or Trouble.3. Choose Add > Delay.4. Choose Delay Type, then choose when to initiate the delayresponse.5. Choose Delay Time, press Del four times, and then enterhow many seconds you want the delay to last.6. Choose Exit > Save Edits.Technical Manuals Online! - http://www.tech-man.com |
This manual is suitable for:
Product
Learn More
Legal
Copyright © 2024 OneStart. All Rights Reserved