Menu
Ge Est QS4 Technical Reference Manual
                                                                                                                                          | |
Contents
| 
Operating instructionsQS4 Technical Reference Manual 3.11QuickReference listRequired access levelWhat is it you want to do L1 L2 L3 L4Change smoke detector sensitivity settings to their alternate values Change smoke detector sensitivity settings to their primary values Change the current state of an LED (manual override) Change the current state of an output circuit (manual override) Change the password required for Level 1 access Change the password required for Level 2 access Change the password required for Level 3 access Change the password required for Level 4 access Disable or enable a device Disable or enable a switch on a zone display Disable or enable a zone Disable or enable all the devices on a single card Disable or enable an And Group, Matrix Group, or Time Control Disable or enable the mapping function on an SLIC Get a list of all the active points on a panel Get a list of all the hardware and software components installed on apanel and their revision levels Get a list of smoke detectors that may require servicing (DIRTY attributegreater than 20%) Get a list of smoke detectors that require servicing (DIRTY attributegreater than 80%) Get the attributes for a single smoke detector Get the attributes for all the smoke detectors on a single SLIC Identify output devices that are turned on Identify active points in a Service Group that is being tested Identify points that are disabled Identify points that are in their active state Identify points that are in trouble Log onto the panel as a Level 2 operator Log onto the panel as a Level 3 operator Log onto the panel as a Level 4 operator Perform a lamp test Technical Manuals Online! - http://www.tech-man.com |
This manual is suitable for:
Product
Learn More
Legal
Copyright © 2024 OneStart. All Rights Reserved