CHAPTER 4: Advanced Hardware Setup46www.gateway.com9 Press the - (minus) or +(plus) keyrepeatedly to adjust the multiplier, thenpress Enter.10 Press F10 to exit BIOS, then press Y toaccept the changes. The screen displaysthe message “Turn off power and reinstallthe jumper in Normal mode position.”11 Turn off the computer.12 Disconnect the power cord and follow allanti-static precautions.13 Return the jumper to the Normal position(bridging pins 1-2).14 Reconnect the power cord.15 Turn the computer on. If the jumper is inthe correct position and the multiplier islow enough, your computer should startnormally.Setting up multiple monitorsUsing a projector or second monitorImportantThe dialog boxesshown in this sectionare for demonstrativepurposes only andmay not represent thescreens on yourcomputer.If your computer’s video card supportsadditional monitors (it must have two videoconnections), you can connect an additionalmonitor or projector to your computer.You can use the second monitor or projector asa duplicate of the primary display, or as anextension to roughly double the size of yourWindows desktop. Use the additional desktopspace to accommodate additional windows.To use a projector or additional monitor:1 Turn off your computer.
