Preparing to replace or add a drive 23n If only one drive is attached to a controller cable, configure the drive assingle if it is a hard drive or master if it is a CD drive. If two drives ofany type are attached to the cable, configure one as master and one asslave.n You may need to configure the drives you install using the BIOS Setuputility program. Press F1 at start up to access the BIOS Setup utilityprogram.Drive cabling informationThree drive cables are included with your system. The diskette drive connectorcable is used to connect diskette drives and other non-IDE devices such astape backup drives. The two IDE connector cables are used to connect IDEdevices such as CD drives and hard drives.If you want to add additional drives, you can replace the drive connectorcables with ones that contain three connectors, which would let you add atotal of four IDE devices or two diskette drives.Important If you choose to buy another IDE or SCSI hard drive, youmust also buy the appropriate IDE or SCSI controller card.Diskette DriveConnector Cable IDE Connector Cables (two cables)To floppyconnector onriser cardTo diskettedrive thatcame withyour systemBlack to connectoron IDE drive80 wire cable40 wire cableBlack tosecondaryIDE connectoron riser cardBlue toprimary IDEconnectoron risercardBlack to connectoron CD drive
