Setup Menus 95Boot MenuThe boot menu contains seven fields that allow you to control the bootprocess. Three of these fields open submenus. Table 22 lists the fields andthe options for each.Baud Rate 960019.2k38.4k115.2kWhen console redirection is enabled, this fieldselects the baud rate.When the Emergency Management Port (EMP)shares the COM port as console redirection, thebaud rate must be set to 19.2k to match theEMP baud rate, unless you use the autobaudfeature.Flow Control No flow controlCTS/RTSXON/XOFFCTS/RTS + CDNone disallows flow control.CTS/RTS is hardware flow control.XON/XOFF is software flow control.CTS/RTS +CD is hardware plus carrier-detect flowcontrol.Table 22: Boot MenuField Options DescriptionFloppy Check DisabledEnabledIf Enabled, system verifies the diskette type onboot.Disabled results in a faster boot.Multi-boot Support DisabledEnabledThis option should remain enabled unless youinstall more than eight hard drives in thesystem.Boot Device Priority N/A Enters submenu.Hard Drive N/A Enters submenu.Removable Devices N/A Enters submenu.Maximum Number ofI2O Drives14Selects the maximum number of I 2 O drivesassigned a DOS drive letter.Message TimeoutMultiplier1, 2, 8, 10, 50,100, 1000All timeout values are multiplied by this number.Table 21: Console Redirection Submenu (Continued)Field Options Description
