Garmin zumo 595 Owner's Manual

Also see for zumo 595: Installation instructions

Garmin zumo 595 Owner's Manual Manual pdf 5 page image

InstallationMounting Your Device in a MotorcyclePowered Motorcycle MountWARNINGGarmin®strongly recommends having an experienced installerwith the proper knowledge of electrical systems install thedevice. Incorrectly wiring the power cable can result in damageto the vehicle or the battery and can cause bodily injury.See the Important Safety and Product Information guide in theproduct box for product warnings and other importantinformation.The device must be mounted in a suitable and secure locationon your motorcycle, based on available power sources and safecable routing.À Motorcycle cradleÁ 12 to 24 Vdc system power (red) with in-line fuseÂ System ground (black)Motorcycle Mount Wiring HarnessÀ USBÁ 12 to 24 Vdc system power (red) with in-line fuseÂ System ground (black)Ã 2.5 mm microphoneÄ 3.5 mm stereo line-out audioÅ 3.5 mm stereo line-in audioInstalling the Handlebar BaseThe device includes parts for two handlebar installationsolutions. Custom mounts may require additional hardware.Installing the U-bolt and Handlebar Base1 Place the U-bolt À around the handlebar Á, and thread theends through the handlebar base Â.2 Tighten the nuts to secure the base.NOTE: The recommended torque is 50 lbf-in (5.65 N-m). Donot exceed torque of 80 lbf-in (9.04 N-m).Installing the Handlebar Base to the Clutch-Clamp or Brake-Clamp Brackets1 Remove the two factory bolts on your clutch-clamp or brake-clamp bracket À.NOTE: Both 1/4 in. standard and M6 bolts are included.Match the size of the factory bolts on your clutch-clamp orbrake-clamp bracket.2 Thread the new bolts Á through the handlebar base, spacersÂ, and clutch-clamp or brake-clamp bracket.3 Tighten the bolts to secure the base.Attaching the Base Plate to the Motorcycle MountNOTICEDirect, sustained contact with the base plate, or any part of themotorcycle, may damage the mount over time. To prevent thiskind of damage, you must place the mounting spacers betweenthe mount and base plate, and make sure that no part of thedevice or mount touches the motorcycle.1 Thread the M4 x 20 mm panhead screws À through thewashers Á, cradle, spacers Â, and base plate Ã.2 Tighten the nuts to secure the base plate.Attaching the Base Plate to the Handlebar Base1 Align the ball of the handlebar base À and the ball of thebase plate Á with each end of the double-socket arm Â.Installation 1