Garmin Zumo 660 Owner's Manual

Also see for Zumo 600 Series: Owner's manual

Garmin Zumo 660 Owner's Manual Manual pdf 9 page image

zūmo 600 Series Owner’s Manual Getting StartedMounting Your zūmo on aMotorcycleWarning: Incorrectly wiring the powercable with bare wire leads can result indamage to the vehicle or the battery andcan cause bodily injury. Garmin stronglyrecommends having an experiencedinstaller with the proper knowledge ofelectrical systems install the unit.Step 1: Connecting Power to theMountSelect a suitable and secure location tomount the zūmo on your motorcycle basedon available power sources and safe cablerouting.CradleHeadphone/audio out jack (3. mm)Microphone jack (2. mm)Mini-USB connector(for traffic receiver)Bare wires withinline fuse forpower connectionPower cableStep 2: Installing the HandlebarBaseThe zūmo includes parts for two handlebarinstallation solutions. Custom mounts canrequire additional hardware (www.ram-mount.com).A) To install the U-bolt and handlebarbase:1. Place the U‑bolt around the handlebar,and thread the ends through thehandlebar base.2. Tighten the nuts to secure the base. Donot overtighten.noTe: The recommended torque is 50lbf-in. Do not exceed torque of 80 lbf-in.HandlebarbaseHandlebarU-boltB) To install the handlebar base to theclutch/brake clamp bracket:noTe: Both 1/4” standard and M6 boltsare included. Match the size of the factorybolts on your clutch/brake clamp bracket.1. Remove the two factory bolts on yourclutch/brake clamp bracket.2. Thread the new bolts through thehandlebar base, spacers, and clampbracket.3. Tighten the bolts to secure the base.Clutch/brakeclamp bracketHandlebarbaseSpacers