Garmin Zumo 395 Owner's Manual

Also see for Zumo 395: Quick start manual Installation instructions

Garmin Zumo 395 Owner's Manual Manual pdf 6 page image

Attaching the Base Plate to the Motorcycle MountNOTICEDirect, sustained contact with the base plate, or any part of themotorcycle, may damage the mount over time. To prevent thiskind of damage, you must place the mounting spacers betweenthe mount and base plate, and make sure that no part of thedevice or mount touches the motorcycle.1 Thread the M4 x 20 mm panhead screws À through thewashers Á, cradle, spacers Â, and base plate Ã.2 Tighten the nuts to secure the base plate.Attaching the Base Plate to the Handlebar Base1 Align the ball of the handlebar base À and the ball of thebase plate Á with each end of the double-socket arm Â.2 Insert each ball into the double-socket arm.3 Tighten the knob slightly.4 Adjust for optimal viewing and operation.5 Tighten the knob to secure the mount.Installing Your Device in the Motorcycle Mount1 Fit the bottom of your device into the cradle.2 Tilt the device back until it snaps into place.3 If the latch on top of the mount stays up after you insert thedevice, press it down.Removing Your Device from the MotorcycleMount1 Press the release button on the side of the mount.2 Lift out the device.Mounting Your Device in an AutomobileNOTICEBefore mounting the device, check the local laws pertaining towindshield mounting.WARNINGThis product contains a lithium-ion battery. To prevent thepossibility of personal injury or product damage caused bybattery exposure to extreme heat, store the device out of directsunlight.Do not use the suction cup mount on a motorcycle.See the Important Safety and Product Information guide in theproduct box for product warnings and other importantinformation.1 Plug the automotive power cable À into the port Á on themount.2 Remove the clear plastic from the suction cup Â.3 Clean and dry your windshield and the suction cup with a lint-free cloth.4 Press the suction cup to the windshield, and flip the lever Ãback toward the windshield.5 Snap the cradle Ä onto the suction cup arm.6 Fit the bottom of your device into the cradle.7 Tilt the device back until it snaps into place.8 Plug the other end of the automotive power cable into apower outlet.Getting StartedWARNINGSee the Important Safety and Product Information guide in theproduct box for product warnings and other importantinformation.• Update the maps and software on your device (Support andUpdates, page 3).• Mount the device and connect it to power (Installation,page 1).• Pair your Bluetooth®phone and headset (Pairing Your Phoneand Headset, page 12) (optional).• Acquire GPS signals (Acquiring GPS Signals, page 3).• Adjust the screen brightness (Adjusting the ScreenBrightness, page 4).• Navigate to your destination (Starting a Route, page 5).2 Getting Started