Garmin StreetPilot i2 Set Up And Go Manual

Also see for StreetPilot I2 - Automotive GPS Receiver: Safety and product information Declaration of conformity Specifications Owner's manual Set up and go

Contents

Garmin StreetPilot i2 Set Up And Go Manual Manual pdf 1 page image

➋ Set Up the i2/i3Press and hold the Power button toturn on the i2/i3. Follow the instructionson the screen to set up the i2/i3. Rollthe Wheel up and down to highlightoptions. Press in to select options.➌ Install Software and Load MapsDo not connect your i2/i3 to your computer until you are told to do so!1. Insert the Setup DVD-ROM into your computer’s DVD-ROMdrive.If the welcome screen does not automatically appear, clickStart and then Run on your personal computer. Type theletter of your DVD-ROM drive followed by setup.exe (example:D:\setup.exe). Then press Enter.2. Follow the instructions on the screen to install software andload maps to your i2/i3.3. When MapInstall opens, click the map to select the regions youwant to load to your i2/i3. Selected maps are shaded pink.Find a Place and Go!Select Start Navigating.➎Select a destination.➍Enjoy the route!➏Select a category.➌Select Food, Hotels,and More.➋Select Where To?➊Tip: To narrow your search, select the field and enter letters in the name ofthe place.➍ Mount the i2/i31. Place the suction cup mount on your windshield with the leverpulled toward you, as shown above.2. Press the lever toward the windshield.3. Plug one end of the vehicle adapter into the USB port on thei2/i3. Plug the other end into a receptacle in your vehicle.Windshield USB portLeverPowerWheelGetting Started➊ Insert Batteries1. Press down on the tab and pull to remove the battery door.2. Insert two AA batteries.3. Press down on the battery door as you slide it back into place.TabSetupDVD-ROM Unlock sheetUSB cableVehicle adapter cablei2/i3 and mountWARNING: For use in vehicles, it is the sole responsibility of the owner/operator of a vehicle with the i2/i3 installedto place and secure the device so it will not interfere with the vehicle operating controls and safety devices, obstruct thedriver’s view of driving conditions, or cause personal injury in the event of an accident.NOTICE TO STATE OF CALIFORNIA DRIVERS: California Vehicle Code Section 26708 (a) (1) provides thatdrivers in California should not use suction mounts on their windshield or side or rear windows. Other Garmin dashboardor friction mounting options should be used. For available accessories, refer to the Garmin Web site at www.garmin.com.Also, refer to the Owner’s Manual for instructions on using the included mounting disk with the suction cup mount.Keep batteries installed in your i2/i3 so it can find satellites quickly.NOTE: Keep your Unlock sheet in a safe place for future reference.

/ 2

Related manuals for Garmin StreetPilot I2 - Automotive GPS Receiver