Garmin STREETPILOT 2820 Setup Manual

Also see for StreetPilot 2820: Owner's manual Owner's manual Declaration of conformity

Contents

Garmin STREETPILOT 2820 Setup Manual Manual pdf 1 page image

➌ Configure your StreetPilot 2820.1. Flip the power switch down to turn on your 2820.2. Follow the screen prompts to configure the 2820; you only have to do this once.➍ Pair your cellular phone with Bluetooth® wireless technology to your StreetPilot 2820.1. Press the MENU key.2. Touch Settings > Bluetooth > Manage Connections.3. If you have never paired a device with your 2820, touch Yes. If you have already paired a device with your 2820 and wantto add another, touch Add Device.4. Set your phone to “Find Me,” “Discoverable,” or “Visible” mode. Touch OK on the 2820.5. Touch your device in the list.6. If your phone model appears in the list, touch it. If not, touchOther Phones….7. When pairing your phone, enter the 2820’s PIN code (1234)into your phone when prompted.8. From the Main menu, touch Phone. Use the Mobile Phonemenu to place calls and review your call history.NOTE: You must have the external microphone connected or aheadset with Bluetooth wireless technology paired to your 2820 in order to place a call.Finding a Destination➋ Touch Food, Hotel…. ➌ Touch and Recreation.➊ Touch Where To?➍ Touch a category. ➏ Touch Go To.➎ Touch a place.Following Your RouteFollow the route to your destination using the map. As you travel, your2820 guides you to your destination with voice prompts, arrows, anddirections along the top of the map. If you depart from the originalroute, your 2820 recalculates the route and provides new routeinstructions.WARNING: For use in vehicles, it is the sole responsibility of the owner/operator of a vehicle with the 2820 installed to place and secure the device so it doesnot interfere with the vehicle operating controls and safety devices, obstruct the driver’s view of driving conditions, or cause personal injury in the event of anaccident.Getting Your StreetPilot 2820 ReadyTo use the mounting base with adhesive disks, start with ➊. To use the non-skid friction mount, start with ➋.➊ Attach the mounting base to your dashboard.1. Clean and dry the area where you want to place the mountingbase.2. Remove the liner from the bottom of the base.3. With the locking lever facing you, position the base on the cleanedarea. Apply pressure to adhere the base to the dashboard.➋ Mount your StreetPilot 2820 to the base.1. Align the power plug on the vehicle adapter to the connector andslide the plug until fully seated.2. Slide the locking lever on the base to the left (unlocked).3. Slide the bottom of the 2820 into the base until it clicks into place.4. Slide the locking lever to the right (locked).5. Plug the power cable into a 12-Volt receptacle in your vehicle.6. Route the cable so it does not interfere with vehicle operation.© Copyright 2006 Garmin Ltd. or its subsidiariesMay 2006 190-00633-01 Rev. B Printed in TaiwanYour route is marked with a magenta line.Follow the arrows.A checkeredflag marks yourdestination.StreetPilot®2820setup and go!Mobile Phone menuIndicates yourcellular phone’sbattery level andsignal strengthPowerplugLocking lever Release tabMountingbase Powerswitch

/ 2

Related manuals for Garmin StreetPilot 2820