Garmin Quest 2 Quick Reference Manual

Also see for Quest 2: Owner's manual Quick reference guide Owner's manual Owner's manual Declaration of conformity

Garmin Quest 2 Quick Reference Manual Manual pdf 1 page image

POWER—press and hold to turn the unit on or off. Press once toadjust the illumination of your screen.IN/OUT—press to zoom in or zoom out on the Map page.MENU—press to view a menu of options for the current page.Press twice to open the Settings menu. Press and hold to openthe Route Options menu.SPEAK—press to trigger the unit’s “voice” to repeat the next turnor current destination when navigating a route. Press and hold toadjust the volume.FIND—press to search for cities, addresses, and other POIs.Press twice to view the Recent Finds menu. Press and hold to“Route Home”.PAGE—press to cycle through pages, close the current windowor menu and return to the previous page, or cancel data entry andrestore the previous value.OK—press to select items. Press to show information pages whenpanning the map. Press and hold to save your current location inMy Locations.Rocker—press up, down, right, or left to highlight options or movethe map pointer.To turn on the Quest 2:Press and hold the Power key on the front of the unit to turn iton or off.note: The first time the Quest 2 acquires satellites it may take severalminutes. Afterward, acquisition times are quicker during normal use.note: If you are prompted to enter a security code, contact yourToyota dealer.To install the Quest 2 in your vehicle:1. Flip the GPS antenna to a 90° angle on the back of the Quest 2.2. Insert the bottom of the Quest 2 into the bottom of the mount, asshown. The antenna fits through the opening in the back of the mount.3. Snap the Quest 2 back into the mount so that it is fully seated.© Copyright 2006 Garmin Ltd. or its subsidiariesSeptember 2006 190-00675-10 Rev. A Printed in TaiwanTo find a place and route to it:1. Press the FIND key.2. Use the Rocker highlight a search category.Then press the OK key. A list of places nearyour current location appears.3. Highlight the place you want to visit andpress OK. An information page appears.4. Highlight Route To on the information pageand press OK. Your Quest 2 calculates theroute. Follow the calculated route to thedestination.To stop or resume the current route:1. Press the MENU key, highlight RouteOptions, and press OK. A Route Optionsmenu appears.2. Highlight Stop Navigation or ResumeNavigation, and press OK to stop or startthe active route.note: When the vehicle is moving, Safe Mode turns on automatically.If you press FInD while driving, only the Emergency & GovernmentServices search category is available.Using the KeysFinding Places and Routing to ThemFind PageInformation Pagepocket-sized navigatorQuest®2Turning the Quest 2 On and Installing the UnitQuick Reference Guide

/ 2

Related manuals for Garmin Quest 2