GE PVW7361 Owner's Manual

Also see for JVW5301, JVW5361: Owner's manual Installation instructions Installation instructions Installation instructions Owner's manual

Contents

GE PVW7361 Owner's Manual Manual pdf 7 page image

29-60667CARE AND CLEANING: FiltersFilters (Pyramid Models JVW5301, JVW5361)Be sure the circuit breaker is off and all surfaces are cool before cleaning or servicing any part of the vent hood.Metal Grease FilterThe metal filters trap grease during cooking.The filter must ALWAYS be in place when the hood is inuse. The grease filter is dishwasher-safe and should becleaned every 6 months, or as needed.To remove:Pull downward on the filter lock to release the filter.To replace:Fit the tabs at the bottom of the filter into the slots in theback of the filter opening. Lift up the front side of the filterand push gently until the filter locks into place. Make surethe filter lock is in the closed position to secure the filter.To clean, swish the filter in hot soapy water and rinsein clean water or wash it in the dishwasher. Do not useabrasive cleansers.NOTE: Some discoloration may occur in the dishwasher.For Recirculation Installation OnlyCharcoal Filter (Not Included)If the model is not vented to the outside, the air needs tobe recirculated through a disposable charcoal filter thathelps remove smoke and odors.NOTE: DO NOT rinse, or put charcoal filter in anautomatic dishwasher.The charcoal filter cannot be cleaned. It must bereplaced. It is recommended that the charcoal filterbe replaced every 6-12 months or if it is noticeablydirty or discolored.Order Charcoal Filter JXCF72.To inquire about purchasing replacement charcoal filters,contact your local GE Appliances dealer or authorizedGE parts distributor.To install:1. Remove the metal filters—see Metal grease filtersection.2. Place the side of the charcoal filter with the tabsagainst the side of the blower.3. Align the double lines on the charcoal filter with the"unlocked" symbol on the blower.4. Push and twist the charcoal filter downward until thedouble lines align with the "locked" symbol on theblower.5. Repeat with second filter on the other side of theblower.6. Replace the metal filters—see Metal grease filtersection.To remove:1. Remove the metal filters—see Metal grease filtersection.2. Twist the charcoal filters upward on both sides of themotor to align the double lines with the "unlocked"symbol. The locks are now disengaged and thecharcoal filters can be removed.NOTE: The 30"(76.2 cm) modelshave 2 grease filters.The 36" (91.4 cm)models have 3 greasefilters.