GE PVB37 Installation Instructions Manual

Also see for Monogram ZVB30: Installation instructions Owner's manual Installation instructions Installation instructions Installation instructions

Contents

GE PVB37 Installation Instructions Manual Manual pdf 13 page image

13Installation Instructions4 coNNecT poWeRPlug power cord into properly grounded receptacle.cleANINGpainted or Stainless Steel SurfacesTo clean the stainless steel or painted surfaces,use warm, sudsy water or a stainless steel cleaneror polish.The filters should be washed by hand. Do not cleanfilters in the dishwasher.5 INSTAll fIlTeRS, check opeRATIoN• Press and hold the ON/OFF pad on the controlto raise the vent.• Slip fingers into the vent holes. Lift the ventstraight up and then down.• Slide filter into the retainers and close the vent.• Press the Fan Speed hIGhER pad to start theblower. Adjust the blower by pressing hIGhER orLOWER. The blower, if left on, will automaticallyturn off when the vent is lowered.NoTe: It is not necessary to turn the fan OFFbefore lowering the vent. The fan will automaticallyturn off when the vent is lowered. When the fanis not turned off before lowering the vent, it willautomatically come on at the previously set speedwhen the vent is fully raised.To lower the vent, press the ON/OFF pad.IMpoRTANT: The vent can be activated by pressingthe pads on the switch. Do not use excessive forceor sharp objects to activate the switch. Damagecould occur and void the warranty.Filter Tabs

/ 16

Related manuals for GE Monogram ZVB30