2Safety InformationWARNING: To ReDuce The RISkof fIRe, elecTRIc Shock oR INjuRy To peRSoNS,obSeRVe The folloWING.A. Use this unit only in the manner intended bythe manufacturer. If you have questions, contactthe manufacturer.b. Before service or cleaning unit, switch poweroff at service panel and lock the servicedisconnecting means to prevent power frombeing switched on accidentally. When theservice disconnecting means cannot be locked,securely fasten a prominent warning device,such as a tag, to the service panel.• Do not attempt to repair or replace any partof the downdraft system unless it is specificallyrecommended in this book. All other servicingshould be performed by a qualified technician.• For general ventilating use only. Do not useto exhaust hazardous or explosive materialsand vapors.• Installation work and electrical wiring mustbe done by a qualified person(s), in accordancewith all applicable codes and standards includingfire-rated construction.cAuTIoN: To reduce the risk of fireand to properly exhaust air, be sure to duct airoutdoors. Do not vent exhaust air into spaceswithin walls or ceilings or into attics, crawl spacesor garages.befoRe you beGINRead these instructions completely and carefully.• IMpoRTANT – Save these instructionsfor local inspector’s use.• IMpoRTANT – Observe all governingcodes and ordinances.• Note to Installer – Be sure to leave theseinstructions with the consumer.• Note to consumer – Keep these instructionsfor future reference.• Skill level – Installation of these vents requirebasic mechanical and electrical skills.• completion Time – 1 to 3 hours.• Proper installation is the responsibility of theinstaller. Product failure due to improperinstallation is not covered under the warranty.If you received a damaged vent, you shouldimmediately contact your dealer or builder.for Monogram local service in your area,1.800.444.1845.for Monogram service in canada,1.800.561.3344.for Monogram parts and Accessories,call 1.800.626.2002.WARNING:This appliance must be properly grounded.WARNING:To ReDuce The RISk of fIRe, uSe oNly MeTAlDucTWoRk.