Chapter 3. Configuration74 PACSystems* RX3i & RSTi-EP PROFINET IO-Controller User Manual GFK-2571N3.7.5.2 The Change Submodule ListOn the Change Submodule List, select the type of inputs or outputs that will be wired to the module, and dragthe selection to the Content field in the left pane. For example:Figure 70: Selecting the Sub-Module Configuration with Jumper Settings DeclaredOnce the Content field has been populated, the Description field indicates how the physical jumpers in themodule should be configured. The +10 Vdc analog inputs selected in Figure 70 do not require the installation ofjumpers on the module. If selected, the other choices for this particular module would require jumpers. It isimportant to ensure that the jumper installation matches the configuration for that module in PME. In theevent the jumper settings need to be altered due to changing channel requirements, the module configurationin PME should be changed to match by retracing the steps outlined in this section.After choosing the submodule parameters of the module as described above, a subslot appears in theNavigator, and the module’s Configuration Mismatch is cleared:Figure 71: Analog Modules Showing Configuration Mismatch Cleared3.7.5.3 Configuring the Module ParametersDouble-click the subslot (not the module slot) in the Navigator to configure the module parameters. Theremaining configuration steps for these modules is the same as for other VersaMax modules.For a list of VersaMax Analog module subslot configuration choices and jumper settings, refer to ConfiguringAnalog Modules that Have Jumpers in the VersaMax PROFINET Scanner Manual, GFK-2721.
