Controls and FeaturesGloss Conopg HoodControls NOTE: Avoid using food products that produceflames under the range hood.1 POWER ON/OFF. Press to activate (turnon)/deactivate (turn off)the control buttons.When the buttons are active (turned on), theirouter rings will be illuminated. When active(turned on), the hood lights and fan willautomaticall U turn on at their last settings.NOTES:• Alwags deactivate {turn off) the buttons whenthe hood is not in use.• If both the LIGHT and FAN are setto OFF,thebuttons will automaticallu deactivate {turn off)after 10 seconds.2 LIGHT DECREASE ON/OFR Press to turn onand dim the lights. It remembers the last lightlevel used, The buttons allow you to cyclearound to the desired setting. (There are fourlight levels/settings and OFF.)3 LIGHT INCREASE ON/OFF. Press to turn onand brighten the lights. It remembers the lastlight level used. The buttons allow Uou to cyclearound to the desired setting. (There are fourlight levels/settings and OFF.)4 Display. Shows the fan setting,S FAN DECREASE ON/OFF. Press to turn on anddecrease fan settings, It remembers the lastfan level used. The buttons allow you to cyclearound to the desired setting. (Use to set the fanspeed to LOW, MED, HIGH, BOOST or OFF.)6 FAN INCREASE ON/OFF. Press to turn on andincrease fan settings. It remembers the lastfan level used. The buttons allow you to cyclearound to the desired setting. (Use to set the fanspeed to LOW, MED, HIGH, BOOST or OFR)BOOST--Provides five minutes at the maximumfan setting and then automaticall U sets to HIGHfan.SENSOR FEATURE--The hood fan willautomatically turn on at the MED setting andthe display will show AUTO MODE ON if cookingtemperatures become too hot. The fan will stagon for a minimum of 3 minutes and will thenturn off when temperatures cool to anappropriate level.1 2 3 4 5 6LOCATE ON/OFF SWITCH. Grasp the filterhandle, press inward and then pull down.Remove charcoal filter, if present. Reach intothe motor compartment and locate theON/OFF push-button switch on the side of themotoE Press switch to OFF position.