GE Monogram ZSC2000CBB Datasheet

Also see for Monogram ZSC2000CBB: Dimensions and installation information

Contents

installation requirements

GE Monogram ZSC2000CBB Datasheet Manual pdf 1 page image

Monogram.™Specification Created 4/00ZSC2000CBB - GE Monogram Built-In Advantium™ OvenDimensions (in inches)• These ovens may be installed directly into a wallor wall oven cabinetry, 30" minimum width.• The front surface of the oven will be nearly flushwith surrounding cabinetry doors.• This oven can be installed over any GE singleelectric built-in oven or a single GE electric built-inwarming drawer.• This oven must be installed at least 36" abovethe floor.IMPORTANT: This oven is not approved for useabove another built-in Speedcook oven, side byside or under the countertop installations.• For personal safety, this oven cannot be installedin a cabinet arrangement such as an island orpeninsula.• Cabinets installed adjacent to wall ovens musthave an adhesion spec of at least 194°F tempera-ture rating.• Allow for clearance to adjacent corners, walls,drawers, etc.29-25/32"15"(RecessedPortion)21-7/8"15-27/32"*28-7/16"RListed byUnderwritersLaboratoriesFor answers to your Monogram,®GE Profile Performance Series,™GE Profile™ or GE appliance questions, callGE Answer Center® service, 800.626.2000.27/32"14-1/8"15/32"27/32"20-27/32"11/16"7/8"13"9/16"Single Speedcook InstallationProduct rating is 120/208 or 120/240 volt, 60 Hz, 30 Amps. This product must be connected toa supply circuit of the proper voltage and frequency and protected by a time delay fuse or cir-cuit breaker. The power supply should be brought to a separate 30 ampere branch circuit.Wire size must conform to the requirements of the National Electric Code or the prevailinglocal code.Combined Speedcook and Wall Oven Installation:When installed in combination with a GE single wall oven, use separate electricaljunction boxes,OR,Install a single junction box connected to 50 amp. supply circuit or properly ratedsupply circuit.• Refer to single oven installation instructions for electrical requirements ofthat product.• These connections must be made by a qualified electrician. All electricalconnections must meet National Electrical code or prevailing local codes.Combined Speedcook and Warming Drawer installation:When installing the Speedcook oven over a GE electric warming drawer, a separate120V, 60Hz, properly grounded receptacle must be installed. See instructions packedwith the warming drawer.Electrical RequirementsInstallation Requirements*Excludes Handle

/ 3

Related manuals for GE Monogram ZSC2000CBB