CUTOUT DIMENSIONSWARNING³ This trim kit uses air flow from the top, bottom andsides of the trim frame. Blocking the air flow can causethe microwave to function improperly and may causedamage to the microwave.Allow a 1” clearance beyond the edge of the trimframe to provide proper air flow.FOR INSTALLATION ABOVE A BUILT-IN OVEN:Microwave oven should be installed on a 3/8” plywoodbase and supported by 2x4 or 1x2 equivalent runnerson all sides. Base must be capable of supporting aminimum of 100 lbs.2Installation InstructionsMin. depth with receptacle outside cutout – 16”Min. depth with receptacle inside cutout – 18”120 volt – 60 Hertz grounded power receptacle.TOOLS YOU WILL NEED❒ 2 Phillips Screwdrivers (#1 & #2)❒ Drill with 3/32” Drill Bit❒ Pencil❒ Level❒ Tape MeasureDepthHeight1” OverlapWidth1” Overlap1” Clearance beyondtrim frame(on all sides)3” Min.27”models: 1 7/ 8” overlap30”models: 3 5/ 16” overlapBottom of trim kit must beminimum of 36” from floorDimension Trim Kit Cutout27” 30”Height 19 1/ 8” 19 1/8” 17 1/ 16 ± 1/16”Width 26 7/ 8” 29 3/4” 23 1/8 ± 1/ 16”GROUNDING INSTRUCTIONSThis appliance must be grounded. In the event of anelectrical short circuit, grounding reduces the riskof electric shock by providing an escape wire forthe electric current. This appliance is equipped witha cord having a grounding wire with a groundingplug. The plug must be plugged into an outletthat is properly installed and grounded.Consult aqualified electrician or serviceman if the groundinginstructions are not completely understood, or ifdoubt exists as to whether the appliance is properlygrounded.Improper use ofthe grounding plugcan result in a risk ofelectric shock.Do not use anextension cord. If thepower supply cordis too short, have aqualified electricianor serviceman installan outlet near theappliance.Permanent and Correct Installation3-Prong plugGrounding pin3-Prong receptacleGrounded receptacle boxWARNINGELECTRICAL REQUIREMENTSProduct rating is 120 volts AC, 60 Hertz, 14amps and 1.60 kilowatts. This product must beconnected to a supply circuit of the proper voltageand frequency. Wire size must conform to therequirements of the National Electrical Code or theprevailing local code for this kilowatt rating. Thepower supply cord and plug should be brought toa separate 15 to 20 ampere branch circuit singlegrounded outlet. The outlet box should be locatedin the cabinet above the oven. The outlet box andsupply circuit should be installed by a qualifiedelectrician and conform to the National ElectricalCode or the prevailing local code.