Installation instructionsfor your newParts List1. Base Pan2. Rear Duct3. Top Duct4. Trim Kit Frame5. 2 Rear Holdown BracketsScrews A (6 required 2 extra)B (4 required 1 extra)C (8 required 2 extra)Note: This kit has extra screws to prevent servicemen from spendingextra time locating a replacement in case they lose one during installation.Cabinet Cutout Dimensions and SpecificationsAllow 1-1/2" overlap on the top and bottom edges and 3" overlap oneach side of the cutout for this microwave oven trim kit.WIDTH HEIGHT DEPTH24-1/8"±1 ⁄ 8" 17-9/16"±1⁄16" 19" Min. receptacle outside cutout21" Min. receptacle inside cutout120 volt—60 Hertz grounded power receptacle.For Installation Above a Built-In OvenMicrowave oven should be installed on a3⁄8" plywood base and supported by 2x4 or1x2 equivalent runners on all sides. Basemust be capable of supporting a minimumof 100 lbs.Screw A Screw B Screw CCAUTION:• Before you begin—Read these instructions, Use & Care Manual and Important Safety Instructionscompletely and carefully.• This Kit is for use on models: JE1530GW, JE1540AW/GW/WW, JE1550GW/GY/WW/WY, JES1533BW, JES1534BW,JES1634WA/BB/WB, JE1640GA/WA/AB/GB/WB, JE1650AA/GA/WA, JE1660GA/SA/WA/GB/WB/SB, ZE1660SA/SB.• This kit can be installed alone or over any General Electric/Hotpoint/RCA single electric wall oven.• Do not alter or modify any part of this kit or the oven.• Observe all governing codes and ordinances.• Oven must be plugged into a properly grounded 3-hole, 120 volt receptacle as required by theNational Electrical Code.• Unplug the microwave oven before attempting installation of this kit.• Save these instructions (for Local Inspectors and Future Reference).Microwave OvenBuilt-In Trim KitsJX1530MAW, JX1530MBW,JX1530MWW, JX1530MSA21" Min.receptaclein cabinet19" Min.receptacleoutsidecabinet24-1/8"±1/8"17-9/16"±1/16"29-3/4"19-3/4"1 ABCParts Inventory5234