GE JVM2052 Installation Instructions Manual

Also see for JVM2052: Owner's manual Owner's manual Owner's manual Installation instructions Installation instructions

GE JVM2052 Installation Instructions Manual Manual pdf 3 page image

Installation InstructionsA qualified electrician must perform a ground continuitycheck on the wall receptacle before beginning theinstallation to ensure that the outlet box is properlygrounded. If not properly grounded, or if the wallreceptacle does not meet electrical requirements noted(under ELECTRICAL REQUIREMENTS), a qualified electricianshould be employed to correct any deficiencies.WARNING:Risk of Electric Shock.Can cause injury or death:Remove house fuse oropen circuit breaker beforebeginning installation to avoidsevere or fatal shock injury.WARNING: Risk of Electric Shock.Can cause injury or death: THIS APPLIANCE MUST BEPROPERLY GROUNDED to avoid severe or fatal shock.The power cord of thisappliance is equipped witha three-prong (grounding)plug which mates witha standard three-prong(grounding) wall receptacleto minimize the possibilityof electric shock hazardfrom this appliance.Where a standard two-prong wall receptacle isencountered, it must be replaced with a properlygrounded three-prong wall receptacle, installedby a qualified electrician.WARNING: Risk of Electric Shock.Can cause injury or death: DO NOT, under anycircumstances, cut, deform or remove any of the prongsfrom the power cord. Do not use with an extension cord.Failure to comply may cause fire.IMPORTANT SAFETY INSTRUCTIONS3ELECTRICALREQUIREMENTSProduct rating is 120 volts AC, 60 Hertz, 14 amps and1.70 kilowatts. This product must be connected to a supplycircuit of the proper voltage and frequency. Wire size mustconform to the requirements of the National ElectricalCode or the prevailing local code for this kilowatt rating.The power supply cord and plug should be brought to aseparate 15 to 20 ampere branch circuit single groundedoutlet. The outlet box should be located in the cabinetabove the oven. The outlet box and supply circuit shouldbe installed by a qualified electrician and conform tothe National Electrical Code or the prevailing local code.Ensure properground existsbefore useCAUTION: For personal safety,the mounting surface must be capable of supportingthe cabinet load, in addition to the added weight of this63–85 pound product, plus additional oven loads of upto 50 pounds or a total weight of 113–135 pounds.CAUTION: For personal safety, thisproduct cannot be installed in cabinet arrangements suchas an island or a peninsula. It must be mounted to BOTHa top cabinet AND a wall.CAUTION: To avoid the risk of personalinjury (back injury or other injuries due to excessiveweight of the microwave oven) or property damage,you will need two people to install this microwave oven.