GE JVM1630 Installation Instructions Manual

Also see for JVM1635: Owner's manual Owner's manual

GE JVM1630 Installation Instructions Manual Manual pdf 16 page image

OUTSIDE TOP EXHAUST (Vertical Duct)Insert the toggle wings into the holes in the wall andplace the mounting plate against the wall.NOTE: Before tightening toggle bolts and wood screw,make sure the tabs on the mounting plate touch thebottom of the cabinet when pushed flush against thewall and that the plate is properly centered under thecabinet.CAUTION: Be careful to avoid pinchingfingers between the back of the mounting plate andthe wall.Tighten all bolts. Pull the plate away from the wallto help tighten the bolts.3B4ATTACH THE MOUNTING PLATETO THE WALLB116Attach the plate to the wall using toggle bolts. At leastone wood screw must be used to attach the plate toa wall stud. Recommended locations on the mountingplate are indicated by A, B, C and D.Remove the toggle wings from the bolts.Insert the bolts into the mounting plate throughthe holes designated to go into drywall and reattachthe toggle wings to 3⁄4″ onto each bolt.1PopcornConvenience CookingExpress CookPotatoStartPauseCancelOffBeverageReheatSetClockTurntableSurfaceLightVentAdd30 Sec.PowerLevel 0852741963CookTimeDefrostWeight/TimeTimerOn/OffINSTALLATION OVERVIEWB1. Attach Mounting Plate to WallB2. Prepare Top CabinetB3. Adjust Blower MotorB4. Install Exhaust AdaptorB5. Mount Microwave OvenB6. Adjust Exhaust AdaptorB7. Connect DuctworkWallMountingPlateMounting PlateSpacing for Toggles MoreThan Wall ThicknessBolt EndToggleBoltToggle WingsTo use toggle bolts:Installation Instructions2A BC D1” = 2.5 cm; 1’ = 0.3 m