GE JVB37 Owner's Manual & Installation Instructions

Also see for JVB37: Owner's Manual & Installation Instructions Owner's Manual & Installation Instructions Owner's Manual & Installation Instructions Owner's manual and installation instructions Owner's manual and installation instructions

Contents

GE JVB37 Owner's Manual & Installation Instructions Manual pdf 16 page image

16Installation of the downdraft system. Read these instructions completely and carefully.Step 3 is for 36″wide models only. Skip this step if installing a 30″model.Operating Instructions Safety InstructionsInstallation InstructionsTroubleshooting TipsConsumer SupportInstall Raise/Lower SwitchWARNING: Disconnect electrical power fromthe unit before beginning switch installation.Failure to do so could result in personal injury ordamage to the electrical controls.Determine the location for the RAISE/LOWERswitch. The wiring lead is 72″long.n Drill a 3/16″ hole into the desired location.n –If the switch is mounted into a tile surface,drill the hole between the tiles. Use locallyapproved caulking to cover any gaps.n Center the mounting bracket over the hole andmark pilot holes. Remove the bracket and drillpilot holes.n Mount the metal switch bracket with screws(not provided, choose screws for your type ofcountertop or use locally approved adhesive).n Tie a knot in the lead as close to the switch aspossible. This will prevent the lead from beingpulled away from the switch.n Thread the wire lead through the trim mountingbracket and the top of the countertop as shown.n Pull the wire through the hole from theunderside of the countertop and thread thewire lead into the end of the wire box.n Peel film from the back of the cover trim toexpose the adhesive. Press trim onto themounting bracket to set the adhesive.n Peel film from the back of theRAISE/LOWERpad to expose the adhesive. Align with theimpression and press to set the adhesive.n Remove protective coating from the top of thetrim frame.IMPORTANT: Do NOT connect wire leads towhite connector until you have threaded thelead through the countertop hole and throughthe end of the wire box.n Push wire metal leads into the white connectorplug. Pull wire through the box leaving about2″ additional length.n Place plastic strain relief over the wire;the wire should be flat and fit into the area.DoNOT pinch or twist the wire. Snap the strainrelief closed.n Push the strain relief into the hole on the wirebox. It will snap into position.n Secure wire box to vent with screws provided.n Coil the excess wire and position away frommoving parts and cabinet contents.TrimKnotMountingbracketThread electricalleads through hole2 Pin connector3⁄16″ HoleLeadsStrain reliefPull 2″ lengthout of box