Use and Care of Recirculation Hood Models JN322, JN334, JN335,JMW, & JN635 and Ventilating Hood Models JV322, JV324, JV332,JV334, JV335, JV624, JV634, & JV635—IMPORTANT SAFETY C. When cutting or drilling into wall or ceiling,INSTRUCTIONS do not damage electrical wiring and otherhidden utilities.WARNING- TO REDUCE THE RISK D. Ducted fans must always be vented toOF FIRE, ELECTRIC SHOCK, OR the outdoors.INJURY TO PERSONS, OBSERVE E. If this unit is to be installed over a tub orTHE FOLLOWING: shower, it must be marked as appropriatefor the application.A. Use this unit only in the manner intendedby the manufacturer. If you have any questions, WARNING To reduce the risk of fire,contact the manufacturer. use ody metal ductwork.B. Before servicing or cleaning uni~ switchpower off at service panel and lock service “ When using your hood...panel to prevent power t%om being switchedon accidentally. l Never leave surface units unattended at highFor general ventilating use only. Do not use settings. Boilover causes smoking and greasyto exhaust hazardous or explosive materials spillovers that may ignite and spread if hood isand vapors. used. Use surface unit heat settings recommendedby the manufacturer and adequate-size utensils.When you get your new hood... * Never use your cooking appliance for warming,or heating the room. The electrical wiring of yourc Have it installed and properly grounded by a range hood may not withstand the resultingqualified technician in accordance with the excessive heat.installation instructions. l Keep the hood clean and clean grease filter orl Have the installer show you the location ofthe hood circuit breaker or fuse and mark it for replace combination filter as recommended tomaintain good venting and to avoid grease fires.easy reference.l Take the time to read our suggestions for best use. WARNINGTO REDUCE THE RISKOF A RANGE TOP GREASE FIRE:WARNIN& TO REDUCE ??H’E RISKOF FIRE, ELECTRIC SHOCK, OR A. Keep fa, filters and grease ladenINJURY TO PERSONS, OBSERVE surfaces clean.THE FOLLOWING: B. Always tumhood ON when cookingat high heat.A. Installation work and electrical wiring must bedone by qualified person(s) in accordance with C. Use high range settings on range onlyall applicable codes and standards, including when necessary. Heat oil slowly on lowfwe-rated construction. to medium setting.B. The combustion airflow needed for safe D. Don’t leave range unattended when cooking.operation of fuel-burning equipment maybe E. Always use cookware and utensils appropriateaffected by this unit’s operation. Follow the for the type and amount of food being prepared.heating equipment manufacturer’s guideline and (continued nextpage)safety standards such as those published by thenational Fire Protection Association (NFPA),and the American Society for HeatingRefrigeration and Air Conditioning Engineers(ASHRAE), and the local code authorities.Turn the page for Operation and Maintenance instructions.GE Quality Product——