GE JCBP66SPSS Owner's Manual

Also see for ECBP82: Owner's manual and installation instructions

GE JCBP66SPSS Owner's Manual Manual pdf 33 page image

ProblemPossible CausesWhat To Do“F – and a number You have a function • Press theOFF pad. Put the oven back intoor letter” flash error code. operation.in the display If the function code repeats. • Disconnect all power to the range for at least 30seconds and then reconnect power. If the functionerror code repeats, call for service.• If a function error code appears during theself-cleaning cycle, check the oven door latch.The latch may have been moved, if only slightly,from the locked position. Make sure the latch ismoved to the right as far as it will go. Press theOFFpad. Allow the oven to cool for one hour. Put theoven back into operation.Display flashes “bAd” The installed connection • Contact installer or electrician to correct miswire.then “linE” with a from the house to the unitloud tone is miswired.Display goes blank A fuse in your home may be • Replace the fuse or reset the circuit breaker.blown or the circuitbreaker tripped.The clock is turned off from • See theUsing the clock and timer section.showing in the display.Display flashes Power failure. • Reset the clock.Unable to get the Oven control pads were • TheBAKE andBROIL pads must be presseddisplay to show “SF” not pressed properly. at the same time and held for 3 seconds.Power outage, Power outage or surge. • Reset the clock. If the oven was in use, you must resetclock flashes it by pressing theOFF pad, setting the clock andresetting any cooking function.“Burning” or “oily” This is normal in a new • To speed the process, set a self-clean cycle for aodor emitting from oven and will disappear minimum of 3 hours. See theUsing the self- cleaningthe vent in time.oven section.Strong odor An odor from the insulation • This is temporary.around the inside of theoven is normal for the firstfew times the oven is used.No power supply from Small appliance plug is not • Make sure the small appliance plug is properlyconvenience outlet completely inserted in the inserted.on top of backguard convenience outlet.(on some models) The backguard is too hot • Allow the range to cool, then reset the circuitand the convenience outlet breaker by pressing the switch located near thebreaker has tripped. convenience outlet.www.GEAppliances.ca33Safety Instructions Operating Instructions Care and Cleaning Troubleshooting Tips Consumer Support