GE JCBP62 Owner's Manual And Installation Instructions

Also see for ECBP82: Owner's manual

Contents

GE JCBP62 Owner's Manual And Installation Instructions Manual pdf 33 page image

33REPLACE THE STORAGEDRAWERPlace the drawer rail on the guides.Push the drawer in until it stops.Lift the front of the drawer and push inuntil the stops clear the guides.Lower the front of the drawer and push inuntil it closes.DCBA6StopFINAL INSTALLATIONCHECKLIST• Check to make sure the circuit breaker isclosed (RESET) or the circuit fuses arereplaced.• Be sure power is in service to the building.• Check to be sure that all packing materialsand tape have been removed. This willinclude tape on metal panel under controlknobs (if applicable), adhesive tape, wireties, cardboard and protective plastic.Failure to remove these materials couldresult in damage to the appliance once theappliance has been turned on and surfaceshave heated.• Check to make sure that the door anddrawer are parallel to each other and thatboth operate smoothly. If they do not, seethe Owner’s Manual for proper replacement.• Check to make sure that the rear leveling legis fully inserted into the Anti-Tip bracket andthat the bracket is securely installed.7OPERATION CHECKLIST• Turn on one of the surface units to observethat the element glows within 60 seconds.Turn the unit off when glow is detected.If the glow is not detected within the timelimit, recheck the range wiring connections.If change is required, retest again. If nochange is required, have building wiringchecked for proper connections and voltage.• Check to make sure the Clock (on modelsso equipped) display is energized. If a seriesof horizontal red lines appear in the display,disconnect power immediately. Recheck therange wiring connections. If change is madeto connections, retest again. If no change isrequired, have building wiring checked forproper connections and voltage. It isrecommended that the clock be changedif the red lines appear.• Be sure all range controls are in the OFFposition before leaving the range.8Installation InstructionsMODEL AND SERIAL NUMBERLOCATIONThe rating plate is located above the draweron the oven frame or on the side of the drawerframe.Location ofmodel ratingplate