GE IC3645SR4T405CT1 Installation And Operation Manual

GE IC3645SR4T405CT1 Installation And Operation Manual Manual pdf 38 page image

ADJUSTABLE FEATURESIT TRANSISTOR CONTROLS Page 38January 2008Section 5.3 Set-up Function ProceduresWith the Handset connected, hold down the CONT keyand turn on the key switch. This will place you in the set-up mode, ready to monitor or adjust control functionsettings.NOTE: The term “Push” means to depress key forapproximately one second.Section 5.3.1 Setup ModeSET-UP MODEHold Down CONTAnd Turn On Key 8 8 8 8 Segment CheckDisplayedACTION DISPLAYSHOWS REMARKSPush Function Number U 0 0 5 Selected Function No.Is DisplayedAfter One SecondTime Delay 0 8 5 Stored Value For TheFunction Is DisplayedPush CONT 0 8 5 Display ValueWill BlinkChange Value WithAdjustment KnobValue ChangesWhile BlinkingPush STORE 125 New Value Stored AndBlinking StopsPush ESC 8 8 8 8 Segment CheckDisplayed125At this point, another function can be monitored/changedby pushing another function number, or the vehicle can beplaced in the run mode by holding the ESC key down forone second or longer. The display will return to either thediagnostics mode, the BDI display, or a blank display (ifBDI is not used and there are no fault codes). Thevehicle can now be operated with the Handset connected,or the Handset can be disconnected before operation.NOTE: You can return to the segment check mode atany time, by holding down the ESC key until 8888appears in the display.Section 5.3.2 Status Code ScrollingThe SX and IT families of controllers furnish a functionregister that contains the last 16 “stored status codes”that shut down vehicle operation (a PMT type fault that isreset by cycling the key switch) and the battery state ofcharge reading at the time the fault occurred. The first ofthe 16 status codes will be overwritten each time a newstatus code occurs. This stored status code register canbe cleared from memory by using the Handset.Key Switch OffPush ESC and CONTAt The Same TimeRelease ESC and CONTKeyStatus Code DisplayedPush CONT KeyDisplays BatteryState-Of-Charge WhenFault OccurredPush CONT KeyDisplay Hourmeter ReadingWhen Fault OccurredPush CONT KeyACCESSING STORED STATUS CODESWITH GE HANDSETPush ESC toErase StoredDataHold Both theESC and CONTKeys Down toErase All 16Stored CodesPush ESC toErase StoredDataPush ESC toErase StoredDataSection 5.3.3 IT Family Handset, Plug Connectionsand Outline Drawing“Y”PlugHandset Cable Part Number - 171B3990G4