5-80 F60 Feeder Protection System GE Multilin5.2 PRODUCT SETUP 5 SETTINGS5Figure 5–17: USER-PROGRAMMABLE PUSHBUTTON LOGIC (Sheet 2 of 2)User-programmable pushbuttons require a type HP or HQ faceplate. If an HP or HQ type faceplate was orderedseparately, the relay order code must be changed to indicate the correct faceplate option. This can be done viaEnerVista UR Setup with the Maintenance > Enable Pushbutton command.5.2.15 FLEX STATE PARAMETERSPATH: SETTINGS PRODUCT SETUP FLEX STATE PARAMETERS FLEX STATE PARAMETERSPARAMETER 1:OffRange: FlexLogic operandMESSAGE PARAMETER 2:OffRange: FlexLogic operandMESSAGE PARAMETER 3:OffRange: FlexLogic operandMESSAGE PARAMETER 256:OffRange: FlexLogic operandPushbutton 1LEDInstantaneousreset *OR1. If pushbutton 1 LED control is set to off.2. If pushbutton 1 LED control is not set to off.PUSHBUTTON 1 LED LOGICORANDANDSETTING= Disabled= High PriorityMessage Priority= NormalFLEXLOGIC OPERANDPUSHBUTTON 1 ONPushbutton 1LEDSETTING= any FlexLogic operandPUSHBTN 1 LED CTLANDSETTINGFlash Message TimeTRST0PUSHBUTTON ONLATCHEDLATCHED/SELF-RESETANDFrom user-programmablepushbuttons logicsheet 1, 842021A3FLEXLOGIC OPERANDPUSHBUTTON 1 ONFLEXLOGIC OPERANDPUSHBUTTON 1 OFFSETTINGT RST0Instantaneousreset *LCD MESSAGEENGAGE MESSAGESETTINGS= XXXXXXXXXXTop Text= XXXXXXXXXXOn TextThe message is temporarily removed ifany keypad button is pressed. Ten (10)seconds of keypad inactivity restoresthe message.LCD MESSAGEENGAGE MESSAGESETTINGS= XXXXXXXXXXTop Text= XXXXXXXXXXOn TextInstantaneous reset will be executed if anyfront panel button is pressed or any newtarget or message becomes active.842024A2.CDRORFLEXLOGIC OPERANDPUSHBUTTON 1 ONPUSHBUTTON 2 ONPUSHBUTTON 3 ONPUSHBUTTON 16 ONFLEXLOGIC OPERANDANY PB ONThe enhanced front panel has 16 operands;the standard front panel has 12Flash Message TimeNOTE
