21TOOLS YOU MAY NEEDInstallation RefrigeratorInstructions GE Café™ modelsQuestions? Call 800.GE.CARES (800.432.2737) or visit our Website at: GEAppliances.comIn Canada, call 1.800.561.3344 or visit our Website at: www.GEAppliances.caBEFORE YOU BEGINRead these instructions completely and carefully.WARNING Tip Over Hazard.Built-in style models (model PYE, CYE, and PWE) aretop heavy, especially with any doors open. Thesemodels must be secured with the anti-tip floorbracket to prevent tipping forward, which couldresult in death or serious injury. Read and followthe entire installation instructions for installing theanti-tip floor bracket packed with your refrigerator. IMPORTANT ³ Observe all governing codesand ordinances. Save these instructions for localinspector’s use. Note to Installer – Be sure to leave these instructions withthe Consumer. 1RWHWR&RQVXPHU² Keep these instructions for futurereference. 6NLOOOHYHO²Installation of this appliance requires basicmechanical skills. &RPSOHWLRQWLPH² Refrigerator Installation can varyWater Line Installation 30 minutes 3URSHULQVWDOODWLRQLVWKHUHVSRQVLELOLW\RIWKHLQVWDOOHU 3URGXFWIDLOXUHGXHWRLPSURSHULQVWDOODWLRQLVQRWFRYHUHGunder the Warranty.PREPARATIONMOVING THE REFRIGERATOR INDOORSIf the refrigerator will not fit through a doorway, therefrigerator door and freezer drawer can be removed. 7RUHPRYHWKHUHIULJHUDWRUGRRUVHHWKH,QVWDOOLQJWKHRefrigerator section. 7RUHPRYHWKHIUHH]HUGUDZHUVHHWKH5HPRYLQJWKHFreezer Drawer section.WATER SUPPLY TO THE ICE MAKER AND DISPENSERIf the refrigerator has an ice maker, it will have to beconnected to a cold water line. A GE water supplykit (containing tubing, shutoff valve, fittings andinstructions) is available at extra cost from your dealer,by visiting our website at GEAppliances.com (in Canadaat www.GEAppliances.ca) or from Parts and Accessories,800.626.2002 (in Canada 1.800.661.1616).Adjustable Wrench1/4” Outer DiameterCompression Nutand Ferrule (sleeve) Phillips-Head ScrewdriverȒμ Socket Ratchet/Driver1/8”, 3/32”, 1/4” & 5/32”Allen WrenchesPencil1/8” Drill Bit andElectric or Hand DrillTape Measure1/4” Nut DriverPliers LevelFlat-Head ScrewdriverTorx T20, T25