GE Café series Installation Instructions Manual

Also see for Cafe series: Dimensions and installation information Owner's manual Owner's manual Installation instructions

Contents

GE Café series Installation Instructions Manual Manual pdf 9 page image

Installation InstructionsINSTALLING THE REFRIGERATOR (cont.)Anti-Tip Floor Bracket Installation (Models PYE, CYE, and PWE only)MEASURE CABINET OPENINGAVAILABLE VS. REFRIGERATOR WIDTHMeasure width of cabinet opening where refrigeratorwill be placed, W.Be sure to account for any countertop overhang,baseboard thickness and any clearance desired. Width,W, should not be less than 36”. The refrigerator will beplaced approximately in the middle of this opening.MATERIALS YOU MAY NEED (not included)TOOLS YOU WILL NEEDPencil1/8” (3 mm) Drill Bit andElectric or Hand DrillTape measure5/16” (8 mm) Nut DriverLag Bolts1/4” (6 mm) x 1-1/2” (38 mm)Anchor Sleeves1/2” (12 mm) ODFor Anti-Tip Bracket Mounted on CONCRETE Floors OnlyDrill Bit Appropriate for AnchorsAT-1BaseboardThickness orCountertopOverhang(Whichever IsLarger) PlusAny DesiredClearanceRear WallFront RH SideLOCATING THE ANTI-TIP FLOORBRACKETPlace the anti-tip floor bracket locator template(included inside the anti-tip kit) onto the floor upagainst the rear wall, within W, and in line with thedesired location of the RH side of the refrigerator(see Figure 1).Place the anti-tip floor bracket onto the locatortemplate with its RH floor holes lined up withthe floor holes indicated on the template sheet,approximately 15 ¼” from the edge of the sheet orthe RH side of the refrigerator.Hold down in position and use the anti-tip floorbracket as a template for marking the holes basedupon your configuration and type of constructionas shown in Step 3. Mark the hole locations with apencil, nail or awl.NOTE:It is REQUIRED to use at least 2 screws to mountthe floor bracket (one on each side of the anti-tipfloor bracket). Both must be into either the wallor the floor. Figure 2 indicates all the acceptablemounting configurations for screws. Identify thescrew holes on the anti-tip floor bracket for yourconfiguration.AT-2ABCWREFRIGERATORFigure 1 – Installation OverviewBase Bracketon theRefrigerator2 Wall HolesRH Side ofRefrigeratorFloor – Concrete(2 Holes)Floor – Wood(2 Holes)15 ¼”Locator TemplateSheetFloor Bracketto InstallRH HolesRear RHCorner ofCabinet Wall29WARNING Tip Over Hazard.Built-in style models (model PYE, CYE, and PWE) aretop heavy, especially with any doors open. Thesemodels must be secured with the anti-tip floorbracket to prevent tipping forward, which couldresult in death or serious injury. Read and followthe entire installation instructions for installing theanti-tip floor bracket packed with your refrigerator.NOTE:If you did not receive an anti-tip bracket with yourpurchase, call 1.800.626.8774 to receive one at nocost. (In Canada, call 1.800.561.3344.)For installation instructions of the bracket, visit:www.GEAppliances.com.(In Canada, www.GEAppliances.ca.)Refer tp 239D1142 P001 Pub# 31-45484-2