GE C2S985 Technical Service Manual

Also see for Appliances C2S985: Owner's Manual & Installation Instructions Owner's Manual & Installation Instructions Owner's manual and installation instructions Owner's manual and installation instructions Owner's Manual & Installation Instructions

Contents

GE C2S985 Technical Service Manual Manual pdf 34 page image

– 34 –Igniter Switch AssemblyEach surface burner utilizes a switch housing thatis wired to a single harness. Inside each housingare 2 switches. When the burner valve is advancedfrom the OFF position to the LITE position, theigniter switch closes. The closed igniter switch sendsline voltage to the spark module and activatesall surface burner igniters. At the same time, thelockout error switch opens and removes previouslyapplied line voltage from the ERC at location InWM. When the cooktop is locked out, this removedvoltage allows the ERC to display ERR and sounda continuous error tone. This informs the user thatthey cannot operate the cooktop in the lockoutmode.Left Rear Switch Housing Shown In Off Position(cover removed for clarity)Valve Position Igniter Switch Lockout SwitchOFF Open ClosedLITE Closed OpenOn Open Open5. Remove the 2 Phillips-head screws and two T-15Torx screws holding the control panel to theburner valves.6. Disconnect the 4 wires from the manifold cover.(Continued next page)Igniter SwitchLockoutErrorSwitchVoltageto SparkModuleVoltage toMotor LockoutValveLineVoltageVoltagefrom AUX