GE AF-300 P11 User Manual

Contents

GE AF-300 P11 User Manual Manual pdf 41 page image

4-4 Data subject to change without notice 7/07. © 2007 GE Drives4.3 Entering Data on the Keypad Panel4.3.1 Operation ModeThe screen for normal inverter operation includes a screen for displaying drive operating status and a screen for graphi-cally displaying the status in the form of a bar graph. The operator can switch between both screens by using the function(E45).1) Operating Status (E45=0)2) Bar Graph (E45=1)4.3.2 Setting Digital FrequencyOn the operation mode screen, press or to display the set frequency on the LED. Data is increased ordecreased in the smallest possible unit, depending on which key is pressed. The adjustments in data will occur rapidly ifthe operator holds down or . To select a digit use SHIFT and then data can be set directly. To save thefrequency settings press FUNCDATA .Press RESET and PRG to to return to the operation mode. If keypad panel settings are not selected, the present frequencysetting mode appears on the LCD. When selecting the PID function, the PID command can be set with a process value(refer to technical documentation for details).1) Digital (keypad panel) settings (F01=0 or C30=0)2) Non-digital settingDirection of rotation = blank (no command) or FWD/REVOperating status = STOP (no command) or RUNOutput frequency (maximum frequency at full-scale)Output current (200% of inverter rating at full-scale)Torque calculation (200% of motor rating at full-scale)PRG PRGMENUF/D LED SHIFT60.00STOPPRG PRGMENUF/D LED SHIFT60.00HzA%Fout/Iout/TRQ60.00RUN FWDFrequency setting valueScreen explanationPresent frequency setting modeOperations guide60.00RUNPRG PRGMENUF/D LED SHIFTFWD60.00F/D DATA SETSET Hz>LOCAL50 - 400F/D DATA SETSET Hz>LOCAL50 - 400STORING...56.89 Frequency setting valueScreen explanationPresent frequency setting modeFrequency setting rangeOperations guideWhen FUNCDATA pressed and writing60.00RUNPRG PRG MENUF/D LED SHIFT60.00F/D DATA SET12+V1