GE 15057 Manual

Digital Timer15057-1 7/15/09DO NOT EXCEED THE RATING OF THE TIMER 1000 WATTS FORGENERAL PURPOSE AND TUNGSTEN LOAD (SUCH AS LIGHTING).THIS TIMER IS FOR INDOOR USE ONLY. DO NOT USE IN WETLOCATIONS.THIS TIMER HAS A BUILT-IN RECHARGEABLE BATTERY THAT ISUSED TO RETAIN THE CURRENT TIME AND ON/OFF SETTINGSWHEN THE UNIT IS NOT PLUGGED IN AN OUTLET.IN CASE OF A FAILURE OF THE TIMER. PRESS THE RESET BUTTONTO RESTART THE TIMER.TO ACTIVATE YOUR TIMER1. Display - Remove the plastic film from display.2. Installation - Plug the timer into a grounded outlet and wait for at least30 minutes to charge the built-in rechargeable battery. Once the batteryhas charged, unplug and press the “RESET” button.3. Set Current Time - While holding down the CLK (Clock) button, pressthe DAY, HR (Hour) and MIN (Minute) buttons to set the day, hour andminute. Note the AM or PM appears after the time.4. Release the CLK (Clock) button.Your Timer is now ready to be programmed.PROGRAMMING AN EVENT1. Press the PROG button once. The display will reador if an event has already been programmed the current event will bedisplayed. It will show current settings if it has been previously Thenumber 1 indicates that you are now programming Event until the day youchoosen to program is displayed.2. To select the day to be programmed press the DAY button repeatedlythe display should show the day on which you want the timer to turn ON.The day options includes:- All days of the week (MO TU WE TH FR SA SU)- Any single day of the week (for example WE)- Weekdays only (MO TU WE TH FR)- Weekends only (SA SU)3. Press the HR and MIN buttons to select the time of day to turn theTimer ON press the HR button repeatedly to change from AM to PM.4. Press the PROG button again. The display will read:It will show current settings if it has been previously set.5. Repeat steps 2 and 3 to program other events.6. To set additional ON and OFF cycles (maximum of 7 events) press thePROG button and follow the procedures 2-5 above for each new ON/OFFevent. When you are finished press the CLK button the display will nowshow the current time and the Timer will control the device plugged into itaccording to the programmed events.REVIEWING EVENTSPress the PROG button repeatedly and will cycle throughall the programmed ON/OFF events. Press the CLK to returnto normal operation.CLEARING PROGRAMMED EVENTPress the PROG button repeatedly to find the ON/OFF event you want toclear. While holding the MODE button down, press the PROG to clear thesettings for the event.ACTIVATING YOUR EVENTSAutomatic - For controlled operation according to programmed events,press the MODE button repeatedly until AUTO is displayed.Random - For random operation press the MODE button until RDMis displayed. The Timer will turn ON and OFF at +/- 30 Minutes ofprogrammed events randomly.Manual - For manual operation, press the MODE button until ON(to turn and remain on) or OFF (to turn and remain off) is displayed.OPERATING THE TIMERPlug the Timer into an outlet near where you want time your lighting orappliance. Plug the lighting or appliance into the Timer. Check and adjustthe Timer setting if needed.is a trademark of the General Electric Company and is used under license toJasco Products Company LLC, 10 E. Memorial Road, Oklahoma City, OK 73114.This Jasco product comes with a 1 year limited warranty.Visit www.jascoproducts.com for details.http://waterheatertimer.org/plug-in-timers.html#15057

/ 2

Related manuals for GE 15057