TeamPoS 3000 XL and XL 2 BIOS XL2 MotherboardD900000145 Issue 3 10-1Chapter 10. BIOS Setup Procedures – XL2If a motherboard is replaced in the field, it may be necessary to change the date and timeand setup the BIOS for the customer’s configuration. The following information showsthe default screens from the factory.Motherboard10.1. Opening CMOS Setup ScreenTurn ON power and press the “F2” key while the terminal goes through the power on selftest (POST).10.1.1. CMOS SettingsIf this is a new motherboard it will be necessary to set the date and time before releasingthe terminal to the customer. To change the date and time from the BIOS screen,manually input the current date and time. Run “LOAD SETUP DEFAULTS” then“SAVE & EXIT SETUP.” Changing other default settings may be done at this time if thecustomer has settings other than the default settings listed here. Changing settings thatare not the default or not set for specific customer needs may adversely effect theoperation of the unit.In most cases, the CMOS default settings are adequate and do not require changing.Follow the instructions on the screen to select STANDARD CMOS SETUP.
