TeamPoS 3000 XL and XL2 MaintenanceD900000145 Issue 3 7-537.11 Replacing the Power Supply1. Remove the back panel (See Section 5.1.2).2. Disconnect the power cable from the controller.3. Remove the front panel (See Section 5.1.1). The yellow LED light should be off (SeeSection 1.2).4. Unseat the motherboard.5. Remove the backplane assembly (See Section 7.8).6. Unseat any installed I/O boards. It is not necessary to disconnect the cables, just removefrom the chassis to allow access to one of the mounting screws and the power supplycables.7. Remove the 3 mounting screws. Retain the screws.Screw #1Viewed from front ofPower SupplyScrew #1From RearScrew #2Viewed from rear of PowerSupplyScrew #3Viewed from side ofPower Supply
