Fujitsu ScanSnap Fi-5110EOX2 Installation Procedures Manual

Also see for ScanSnap S300: Specification Getting started guide Operator's guide Cleaning instructions

Fujitsu ScanSnap Installation ProceduresWindows 98SE\ME\2000\XP\VistaRev 120408 Page 1 of 3This document is intended for the installation of the following models of Fujitsu ScanSnapscanners.Fi-5110EOX Fi-5110EOX2 S500 S510 S300Hardware requirements.You will need a PC system that meets our recommended specifications. For recommended PCsystem specifications please reference the Scanner Hardware Reference page. You may alsoneed your Operating System Disk.Step 1:Option A: Installing the drivers from the Setup CD.Before connecting the scanner to the computer we recommend installing the scanningapplications first before installing the driver (ScanSnap Manager). After the applications anddrivers are installed proceed to step 2.Installing Adobe Acrobat.1. Insert the Adobe Acrobat Setup CD into your CD Rom.2. Next click the Install Acrobat button and follow the prompts.3. Do not reboot at this time!4. Eject the Acrobat CD and go to the next step.Installing ABBYY FineReader (S500\S510 - Optional for Fi-5110EOX2).1. Insert the ABBYY FineReader Setup CD into your CD Rom.2. Next click the Install FineReader for Scansnap button and follow the prompts.3. Do not reboot at this time!4. Eject the FineReader CD and go to the next step.Installing ScanSnap Manger, Organizer, and Cardminder.1. Insert the ScanSnap Setup CD into your CD Rom.2. Next click the Install Products button on the Scanner Setup Menu.3. Follow the prompts and install the ScanSnap Manager, Organizer, and Cardminder.4. Once all of the above has been completed then remove the Scansnap Setup CD,Reboot your system.Special note: If you are installing a Fi-5110EOX, Fi-5110EOX2, S500 or S300 on Vista, thenplease follow the additional steps listed below.Installing Vista Service Packs.1. Click here to download the Vista Service Pack for your model scanner, which willcontain updated versions of the following modules.a. ScanSnap Managerb. ScanSnap Organizerc. CardMinder2. Close any open applications.3. Install the three service pack updates listed above. You do not need to rebootbetween each service pack install.4. After the third and final update has been completed reboot your system.5. Go to Step 2.

/ 3

Related manuals for Fujitsu ScanSnap S300