Fujitsu FI-4120C Installation Procedures Manual

Also see for fi-5120C: Specifications Operator's guide Installation procedures Instruction manual Getting started

Fujitsu SCSI Scanner Installation ProceduresWindows NT 4.0Rev051906A Page 1 of 9If you are installing the following models by means of the SCSI interface then use thisdocument.SP10C M3093GX\DG Fi-4530C Fi-5120CSP15C M3096GX Fi-4640S Fi-5220CSP600C M3097G\G+\DG M4097D Fi-5530CSP620C M3099G\GX\GH Fi-4750C\L Fi-5650CSP3091DC FI-4120C\C2 M4099D Fi-5750CSP3092DC Fi-4220C\C2 Fi-4860C Fi-5900CSP93GX Fi-4340C Fi-4990CIf you are going to use the USB interface of a dual SCSI/USB model then use the USB scannerinstallation guide. For Scansnap models please use the Scansnap installation guide.Hardware requirements.You will need a PC system that meets our recommended specifications, an appropriate SCSIcontroller, and a SCSI cable (six foot recommended maximum). For recommended PC systemspecifications and SCSI controllers please reference the Scanner Hardware Reference page.You may also need your Operating System Disk.Step A: Installing the SCSI Host Adapter (Adaptec).1. Shut down your PC and remove the case cover.2. Locate a free PCI slot and remove the back plate if necessary.3. Install the SCSI controller in an open PCI slot.Make sure that the card is seated completely in the slot and secured in the frameWarning! Failure to secure the SCSI controller in the PC can result in damage to theSCSI card, scanner, and/or your system.4. Boot your PC without the scanner attached.Step B: Installing the SCSI drivers (Adaptec).Although Windows NT has driver support for your host adapter it does not support plug andplay. Therefore the SCSI drivers will need to be loaded manually. Follow the instruction belowto install the driver for your host adapter.