197CHAPTER 2 DEPENDENCE FUNCTIONS■ Specifications List• SOFTUNE format- To display in the RAM Checker viewer (recommended)- Default extension is ".SRL".• CSV format- To display in other applications than the RAM Checker viewer- Default extension is ".CSV".Note:The CSV format requires size of data approximately 4 times that of the SOFTUNE format.■ To Use the RAM CheckerUser sets the monitoring points, Log File, logging status by GUI or Command to use the RAM Checker.• GUI- Set the debug function to "RAM Checker" mode by using [Debug] - [Select Debug Function].- By short cut menu [Setup...] on the Ram checker Window, user sets the monitoring points.- By short cut menu [File...] on the Ram checker Window, user sets the Log File.- By checking the short cut menu: [Logging start] on the Ram checker Window, a logging status of theRam Checker becomes to enable.• COMMAND- Set the debug function to "RAM Checker" mode by using SET MODE/CONFIG command.- By command: SET RAMCHECK, user sets the monitoring points.- By command: SET RAMCHECK, user sets the Log File.- By command: ENABLE RAMCHECK, a logging status of the Ram Checker becomes to enable.After these commands are set, user program execute and Log File is created by stopped user program. If it isrestarted, a Log File is overwritten.Note:If a setting of Overwrite control is enabled on Setup file dialog, a Log File is saved with different nameevery other execution.Monitoring Point Count 16 pointsSize Bytes/word (16 bits)Event Functions Max. 8 PointsSampling Time 1 ms (Fixed)Update Intervals 100 ms (Fixed)Log File Formats SOFTUNE format or CSV format
