Fujitsu PRIMEHPC FX1000 User Manual

Also see for PRIMEHPC FX1000: Operating manual

Table 3.27 Operation Items on the [SNMP Trap Settings] ScreenOperation Item DescriptionApply Change SNMP trap setting information. For the procedure, see "ChangingSNMP Trap Setting Information."Reset Restores the currently set SNMP trap information.Test Trap Send a test trap to all of the set trap destinations. For the procedure, see"Sending a Test Trap."Table 3.28 Specifying SNMP Trap Setting InformationInput Item DescriptionIP Address Specify the IP address of an SNMP trap destination in the xxx.xxx.xxx.xxxformat. xxx is a value between 0 and 255.SNMP Version Specify the SNMP version.Figure 3.14 [SNMP Trap Settings] ScreenYou can perform the following operations on the [SNMP Trap Settings] screen.Changing SNMP Trap Setting Information1. To change the setting information for a trap destination, check its check box.2. Specify each item, such as [Community/User], [IP Address], and [SNMP Version].Chapter 3 Web GUI FunctionsC120-0091-02EN3.4 Configuration36