Chapter 9 Connectivity Management9.2 Functions in the Action Area for ConnectivityETERNUS Web GUI User’s Guide373Copyright 2011 FUJITSU LIMITED P2X0-1090-02ENZ0→ A confirmation screen appears.3 Click the [OK] button.→ Modification of the FCoE port parameters starts.4 Click the [Done] button to return to the [Ports] screen.End of procedure9.2.3.11 Modify Port ModeThis function changes the port mode of each port between Channel Adapter (CA) and RemoteAdapter (RA).The port modes of the FC port and the iSCSI port can be changed.If some parameters do not satisfy the input conditions, an errorscreen appears.Port Port Mode UsageFC Port CA CA is used for connecting to the host.RA RA is used for performing REC.iSCSI Port CA CA is used for connecting to the host.RA RA is used for performing REC.• When changing the port mode of a running port from "CA" to "RA",make sure to stop the host access connected to the corresponding CAPort.• When changing the port mode of a running port from "RA" to "CA",make sure to check that there is no session in the corresponding port.• If the port mode has been changed from "CA" to "RA", LUN mappinginformation in the specified CA port will be deleted.• If the port mode has been changed from "RA" to "CA", the AdvancedCopy path information in the specified RA port will be deleted.• The port mode of a port, which is registered to a port group, cannot bechanged.• The port mode of a SAS port cannot be changed.• The port mode of an FCoE port cannot be changed.
