Chapter 9 Connectivity Management9.2 Functions in the Action Area for ConnectivityETERNUS Web GUI User’s Guide362Copyright 2011 FUJITSU LIMITED P2X0-1090-02ENZ0■ When the port mode is "RA"When the type is "1G-iSCSI" or "10G-iSCSI" and the port mode is "RA", specify thefollowing items:● Select Port• PortSelect the target port or select the copy source port.The location options for the selected port are displayed:- CM#x CA#y Port#z (x: CM number, y: CA number, z: Port number)● TCP/IP Settings• IP AddressEnter the IP address of the target port (required).Click the [Test Connection (ping)] button to display the "[Send Ping Command] Screen"(page 367). Specify the IP address to check the connection status of the connectiondestination device and the number of transmissions. Click the [Send] button. When the"ping" command is sent, the settings of the IP address and the connection path for thedestination device can be checked.The following input conditions apply:- 1 - 3 numeric characters- First text box: "1" - "255"- Other text box: "0" - "255"• Subnet MaskEnter the subnet mask of the target port (required).The following input conditions apply:- 1 - 3 numeric characters- All text boxes: "0" - "255"• Default GatewayEnter the default gateway IP address of the target port.- 1 - 3 numeric characters- All text boxes: "0" - "255"• TCP Port No.Enter the TCP port number of the target port between 0 and 28671.Click the [Default] button to set the default TCP port number.
