Fujitsu ETERNUS DX200F Operation Manual

Also see for Eternus DX200F: Configuration guide Configuration guide Configuration guide Safety precautions Configuration guide

Status of the ETERNUS DX is monitored periodically, and the result is displayed as a general status icon withcharacter strings.Table 3.1 General Status of ETERNUS Web GUIStatus Description(green)The ETERNUS DX is in normal state.(red)An abnormality is detected at a power-off, and I/O access from the servercannot be received.(red)The ETERNUS DX is in error state.(orange)The ETERNUS DX is under maintenance.(yellow)The ETERNUS DX is in warning state.For details, refer to "Configuration Guide (Web GUI)".3.3 Displaying Status via ETERNUS CLIThe status of the ETERNUS DX and the usage status of RAID groups, TPPs, and SDPs can be checked by send-ing the status display command via ETERNUS CLI.CLI> show statusSummary Status [Normal]CLI> show statusSummary Status [Error]CLI> show statusSummary Status [Warning]The general status of the ETERNUS DX indicates whether an error status component or a warning status com-ponent exists in the storage system.Table 3.2 General Status of ETERNUS CLIStatus DescriptionEmpty An undefined or uninstalled component exists in the ETERNUS DX.Normal The ETERNUS DX is in normal status.Pinned Data Pinned data exists in the ETERNUS DX.Unused An undefined component is installed in the ETERNUS DX.Warning The ETERNUS DX contains a component that requires preventive maintenance.Maintenance The ETERNUS DX is under maintenance.Error An error has occurred in a component that is installed in the ETERNUS DX.Loop Down The ETERNUS DX is in BackEnd Down status.Not Ready An abnormality is detected and access from the host cannot be received.Subsystem Down The ETERNUS DX cannot be used.Change Assigned CM CM hot expansion recovery is required.Chapter 3 Storage System Monitoring3.3 Displaying Status via ETERNUS CLI26FUJITSU Storage ETERNUS DX200F All Flash Array Operation Guide (Basic)Copyright 2014 FUJITSU LIMITEDP3AM-8472-01ENZ0