Fujitsu ETERNUS DX200F Operation Manual

Also see for Eternus DX200F: Configuration guide Configuration guide Configuration guide Safety precautions Configuration guide

■ Power Supply UnitsThe power supply unit transforms input AC power from a power socket to DC power and supplies power toeach component.Each power supply unit contains fans.Figure 1.9 shows the power supply unit. Table 1.4 shows the status and meanings of each LED.Figure 1.9 Power Supply Unit1 2 3 4 5 61. POWER LED2. FAULT LED3. AC MISSING LED4. FAN FAIL LED5. PSU switchThis switch is used to turn on and off the AC power supply.6. InletThis inlet is used to connect a power cord.The LEDs turn on or blink to indicate the statuses that are listed below.Table 1.4 Status and Meanings of Each LED (Power Supply Unit)LED name LED status MeaningPOWER(green)AC power is supplied to the power supply unit.(blinks green)AC power is supplied to the power supply unit, but DC power isnot supplied to the ETERNUS DX.FAULT(amber)AC power is not supplied to the power supply unit.AC MISSING(amber)AC power is not supplied to this power supply unit, but AC poweris supplied to the other power supply unit.FAN FAIL(amber)The power supply unit or the fan in the power supply unit is in er-ror status.Chapter 1 Component Name/LED Name1.4 Components (Rear)18FUJITSU Storage ETERNUS DX200F All Flash Array Operation Guide (Basic)Copyright 2014 FUJITSU LIMITEDP3AM-8472-01ENZ0